Circuit Breaker Card

If the Dryer is wired for 230V three-phase power, check the control circuit voltage before starting the Dryer, to verify that it is within a 110V to 125V range. Follow instructions on the bilingual Circuit Breaker Card shown below  (5542-1, ships loose).

Once you have completed all the steps in the previous Testing section, and voltages are verified, you are ready to proceed with the following steps.

• Install the Card with the circuit breakers facing toward the I/O Panel. Make sure that the fuse is installed and that it is rated at ten (10) amps.
• Make sure that the connector on the Circuit Breaker Card is lined up with the male end on the I/O Panel.
• Firmly press the Card straight into the connector until the Card is secure and in place. Failure to press the Card straight may cause the male connector to break on the Board.

Copyright © 2014-2016 CTB, Inc. All rights reserved                                                                                                                                                                                                                   BLV0216