safety

2015 Quantum® Controller Manual

Electricity can KILL! Electrical installations MUST be done by a certified/licensed electrician, in accordance with all national, state and local electrical SAFETY codes. Failure to follow these instructions will result in death or serious injury.

Recognize SAFETY Information

This is the Safety-Alert Symbol. When you see this symbol on your equipment or in this Manual, be alert to the potential for personal injury.

Understand Signal Words

DANGER indicates an imminently hazardous situation which, if not avoided, WILL result in death or serious injury.

WARNING indicates a potentially hazardous situation which, if not avoided, COULD result in death or serious injury.

CAUTION indicates a hazardous situation which, if not avoided, MAY result in minor or moderate injury.

Follow SAFETY Instructions

Carefully read all SAFETY messages in this Manual and on your equipment SAFETY signs. Follow recommended precautions and safe operating practices.

Keep Safety signs in good condition. Replace missing or damaged Safety signs.

Failure to follow proper assembly and operational procedures may cause damage to equipment or personal injury.

Locate, read and follow all SAFETY DECAL information on your Dryer, in this Manual and in all supplemental Installation and Owners Manuals.

IMPORTANT! Do not install any auxiliary components in the Control Panel or Monitor. Failure to comply will void the Manufacturer’s Warranty.

Other than factory-approved options, no other devices or equipment should be mounted or installed inside the Dryer Panel Box. All auxiliary equipment (contactors, relays, motors, etc.) should be mounted in a separate box. If any of the options are to be used (Block/Bleed, Aux Unload, Rear Wet Fill, etc), please order the appropriate cable assembly from the Brock Customer Service Department.

The Customer must supply appropriate disconnect equipment between the Dryer Power Panel and the electrical utility as required by local and national electrical codes.

Review and always follow the “Electrical Connection/Disconnection Procedures for Dryer Testing” See Main Menu and the “Manufacturer’s Recommended Minimum Lockout/Tagout Energy Control Procedures” See Main Menu for this Manual.

SAFETY System Check

Your SUPERB® Dryer has many SAFETY controls interlocked to stop the Dryer if a hazardous condition develops. The following controls stop all Dryer functions immediately, and necessitate a MANUAL restart of the Dryer:

SAFETY System Check

Addn'l SAFETY Features