With the exception of a CONVERSION to the BROCK^® QUANTUM^® H2M Controller specifically designed for use with the BROCK^® SUPERB^® Dryer, installing a non-BROCK^® (another manufacturer’s) Controller or any other type Controller on a BROCK^® SUPERB^® Dryer WILL VOID THE WARRANTY on the BROCK^® SUPERB^® Dryer.

It is the responsibility of the Contractor, Installer, Owner and Operator to supplement the Dryer furnished by Brock Grain Systems with any necessary ELECTRICAL or STRUCTURAL items to make the Dryer installation comply with the National Electric Code, National Electric Safety Code, OSHA, and all other applicable federal, state and local laws and ordinances.

Contact only qualified and licensed electrical and gas contractors to install your Dryer and connect its power and fuel sources. Follow recommended precautions and safe operating practices of national and local codes at each installation site.

Dryer installations shall meet the National Fire Protection Association Standard 61B for the prevention of fires and explosions in grain elevators and facilities handling bulk raw agricultural commodities. All components must meet the National Fire Protection Association Standard NFPA No. 70 (National Electrical Code), American National Standard Inst. ANSI-C1, as well as state and local requirements and/or amendments. Failure to follow these standards could result in death or serious injury.

 

Dryer installations

Damage to a Dryer can occur due to improper installations. Dryer foundation pads and/ or Legs must be level and installed correctly before a Dryer is installed.

Improper installation of electrical or fuel sources will void the Warranty and may cause death or serious injury. Installing any non-BROCK^® (another manufacturer’s) components to this Dryer WILL VOID THE WARRANTY on the BROCK^® Dryer. Do not modify or attach any other equipment to the Dryer.

DO NOT use tanks for liquid propane (LP) that have been used for anhydrous ammonia! This includes previously purged tanks that have been used for anhydrous. Gas train components may be damaged, causing a Dryer malfunction which could lead to serious safety hazards and/or fire.

Installing any tank (for an LP fuel supply to the Dryer) which has previously been used for anhydrous ammonia poses a safety threat. Brock Grain Systems will not be held liable for any purging and cleaning methods used for such tanks. If such a tank is used, this will void the Dryer Warranty.

Bypass of factory SAFETY controls and switches is strictly prohibited, and will void the Dryer Warranty.